This services shall be provided through our associate partners.
- Receive and understand architectural, interior and structural drawings for subject premises
- Generate Basis of Design based on above drawings, occupancy, lighting & equipment loads, operational timings, pressurization & sterility requirements, and any special requirements like noise/draught levels, temperature and relative humidity
Carry out heat load / air flow calculations for each area and prepare heat load summary sheet.
Provide capital & operating cost analysis for available options and recommend proper type of system required
Prepare concept drawings showing indoor and outdoor machines single line pipe routes for refrigerant / chilled water / condenser water pipes, cable routes, single line duct routes.
Provide data for other agencies including space requirement and structural loads for machines & pipes / ducts, shaft sizes, water requirement in terms of quality & quantity, power / fuel requirement, typical cutout sizes & locations in shear walls & beams, BMS compatibility provisions etc.
Provide tender draft consisting of
- Bill of Quantities
- Technical Specifications
- Tender Drawings
- List of approved makes
- Format for technical data sheets to be furnished by contractors
- Issue enquiries to pre-qualified contractors, and receive offers
- Providing clarifications on any technical queries raised by contractors
- Preparing techno-commercial comparative statement based on tender offers received
- Issue discrepancy letters to contractors and preparing final corrected techno-commercial comparative statement
- Provide recommendation letter / s based on statement
- Issue GFC drawings to contractor/s, based on originally planned as well as finalized interior layouts
- Guide contractor/s to generate shop drawings
- Approve shop drawings
- Inspection of low side work prior to closure of false ceiling and shafts to ensure conformance of work with respect to shop drawings and specifications
- Certification of running bills, based on measurements carried out by your staff
- Laying performance test formats for various equipment and system/s
- Attending trials and certifying performance with respect to specifications committed in tender submittals
- Approving “as built” drawings prepared by contractor/s